Echo 72854s - Manual (Page 14)

10
Controls and
Identification
3.1. 25 HP Model Controls
1. Engine Throttle Lever: See figure 10.7.
Changes engine speed. Turn knob clockwise for
full throttle operation. Turn knob counterclock-
wise for idle on warm up. Turn knob fully
counterclockwise to shut engine off. Refer to
engine manual for further engine operating
instructions.
2. Engine Choke: Use when starting cold engine.
Pull to ON position when starting. Push lever to
OFF position when engine is running. Refer to
engine manual for further engine operating
instructions.
3. Key Switch: (located to the right of the throttle
lever) Turn clockwise to start engine. Release as
soon as engine is running. Do not crank starter
for more than 10 seconds of damage could
result.
4. Other Engine Components: See Figure 10.8.
3.2. 25 HP Model
Identification
(see figure 10.9)
1. Engine Fuel Tank: Use unleaded fuel; do not
mix with oil.
2. Trailer Hitch: Always use 2 inch ball and safety
chains.
3. Jack Stand: Always have in UP position and
clear from ground when moving. When in use,
place in DOWN position on a level surface.
4. Engine Drive Belt and Shield: Never remove
shields when in use.
5. Chipper Chute: Feed material to be chipped
through the chute.
6. Engine Controls: See figure 10.7.
7. Rotor Access Cover: Open to remove chipper
blades.
8. Engine Battery (not included)
9. Rotor Shaft End Cover: Covers rotor shaft and
bearing. Has lock assembly to lock in place
while moving.
10. Clutch Foot Pedal: Used to engage rotor
assembly drive belt.
11. Adjustable Chipping Block
12. Foot Pedal: Used to pivot machine 360 degrees.
3.3. 28 HP Model
Identification
(see figure 10.10)
1. Extension Tray: Assists in feeding chipping
material. Folds for towing.
2. Feed Control Lever: Move the arm forward to
increase the feed rate. Push back to reverse the
feed.
3. Chipper Chute: Feeds materials to the chipper
blades for chipping.
4. Discharge Tube: Chipped material exits through
this tube. Tube is adjustable 360 degrees.
5. Drive Belt Shield: Never remove shields when
in use.
6. Control Panel: (figure 10.11) Contains the key
switch, throttle control, gauges, indicator lights,
and Murphy switch.
7. Fuel Tank: Fuel level indicator is located on top.
8. Pintle Hitch: Always use safety chains when
towing chipper.
9. Pivoting Tongue Jack: Always have in UP
position and clear from ground when moving.
When in use, place in DOWN position on a level
surface. Turn handle to raise or lower wheel.
10. Battery: (Not included.) Use group 22F 300
CCA min.
11. Clutch Foot Pedal: Used to engage rotor assem-
bly drive belt.
S
E C T I O N
3