Eppendorf FemtoJet express - Manual (Page 52)

100
Other error numbers as well as the error cause and solution are described in Section 5,
"Troubleshooting". During remote control, no error texts appear in the FemtoJet
®
express
display.
Error no. during execution
ERR = [eee] Cause Solution
070 FemtoJet
®
express is not
in routine mode.
Check FemtoJet
®
express.
Bring FemtoJet
®
express into
routine operation.
Eliminate error.
071 FemtoJet
®
express is not
ready.
Check FemtoJet
®
express or
micromanipulator.
As necessary, wait or eliminate
error.
072 The command is not
finished within the
scheduled time. Check FemtoJet
®
express or
micromanipulator.
Eliminate error.
073 This command cannot be
executed at the moment,
because of insufficient
storage pressure.
See: Warning 001 Check FemtoJet
®
express.
Eliminate error.
074 The connected micro-
manipulator did not
respond.
See: Warning 003 Check micromanipulator.
Eliminate error.
9 Appendix A
Appendix A
9
09_AnhangA_en.fm Seite 100 Freitag, 29. Juni 2007 2:52 14