Eppendorf FemtoJet express - Manual (Page 29)

77
Before cleaning the FemtoJet
®
express disconnect the plug.
Ensure that no fluids enter into the inside of the injector in order to avoid short-circuits in the
electrical installation as well as corrosion.
Wipe painted parts and aluminum surfaces using a cloth and mild detergent and then with a dry
cloth.
Warning: Do not use any corrosive, solvent or abrasive detergents or polishes.
Clean the FemtoJet
®
express before disinfecting.
Wipe every part of the FemtoJet
®
express, including accessories and connector cables, with
disinfectant like alcohol (ethanol, isopropanol) or alcoholic disinfection media.
Spray disinfection is not advisable, as disinfectants can enter into the microinjector.
The disinfection method used must comply with current disinfection
regulations and guidelines.
If the device is to be inspected, repaired or calibrated by the service partners of the
Eppendorf AG, it must be free of hazardous substances and clean!
A decontamination certificate must accompany the FemtoJet ® express.
A printed form ("Decontamination certificate for return of goods" and general instructions for
decontamination are available at our www.eppendorf.com homepage.
The serial number of the device must be entered in the decontamination certificate.
Warranty or service is taken over by the supplier or the service partner of the
Eppendorf AG.
4.1 Cleaning
4.2 Disinfection
4.3 Decontamination prior to shipping
4.4 Service
Cleaning and Service
4 Cleaning and Service
4
04_Wartung_en.fm Seite 77 Freitag, 29. Juni 2007 2:50 14