Snorkel SRT2670 - Manual (Page 78)

F
Falling hazards, 1-2
Flashing Light, 7-8, 11-1
G
Gauges
Air Filter, 4-1
Amps, 4-1
Bubble Level, 4-3
Coolant, 4-3
Engine Oil, 4-2
Fuel Level, 4-2
Hours, 4-2
Hydraulic Oil Level, 4-2
Water, 4-1
General Specifications, 3-1
Gradeability, 3-1
Ground clearance, 3-1
Guides rollers and slides, 7-7
H
Hazardous Components, 12-1
Antifreeze (UN 1993), 12-1
Battery, Lead/Acid (UN 2794), 12-1
Diesel Fuel (NA 1993), 12-1
Foam In Tires, 12-2
Gasoline (UN 1203), 12-3
Hydraulic Oil (UN 1270), 12-3
Liquefied Petroleum Gas (UN 1075), 12-4
Motor Oil (UN 1270) , 12-4
Hydraulic oil
leaks, 7-5
Hydraulic oil level, 7-4
Hydraulic tank cap, 7-4
I
Inspection
Operators daily inspection, 7-1
Inspection and Maintenance Table, 7-1
Insulation rating, 3-1
L
Lanyard Anchor Points, 11-2
Level sensor, 7-7
Lift time, 3-1
Lifting the SRT, 10-4
Lower time, 3-1
M
Maintenance personnel
see Introduction - page iii
Maximum height to basket floor, 3-1
Maximum outreach, 3-1
Maximum outreach height, 3-1
Maximum rated axle capacity, 3-1
Maximum width of base, 3-1
Outriggers retracted, 3-1
Minimum Safe Approach Distance
see Electrical Hazard - page ii
N
Nomenclature and Serial Numbers, 3-3
Nominal working height, 3-1
O
Operating Procedures, 8-1
Bubble Level, 8-9
Control Stations, 8-1
Emergency Stopping, 8-1
Extending the platform, 8-10
Operating From Ground Control Box, 8-2
Operating From Platform Control Box, 8-5
Outriggers, 8-8
Raising the outriggers, 8-9
Raising the platform, 8-4, 8-8
Setting the outriggers, 8-8
Warming the hydraulic oil, 8-4
Operator Horn, 11-1
Operators
qualified, 7-1
Outriggers, 8-8, 11-1
Overall height, 3-1
Overall length (with stabilizers), 3-1
Overall length (without stablizers), 3-1
Overall weight, 3-1
P
Parking brakes, 7-9
Placards and decals, 7-10
Inspection drawing, 7-11
Standard placards and decals, 7-10
Platform
Guardrails, 7-6
Lanyard anchorages, 7-6
Platform size, 3-1
Pre-start Inspection, 1-1
Pushing, 9-3
Pushing the SRT, 10-4
index 2 SRT26700 – 11360A
Index