Snorkel SRT2670 - Manual (Page 69)

11. Options
This chapter lists and explains all the options avail-
able for an SRT.
■ Operator Horn
The operator HORN button is on the right side of
the platform control box. For the Horn to work the
Battery switch must be ON and the following
switches, on the ground control box, must be set as
indicated:
Selector Switch .............platform
Emergency Stop ...........out for run
Key Switch ....................on
The operator HORN is used primarily to get the at-
tention of people on the ground when you are work-
ing aloft.
■ Outriggers
The outrigger controls are on the upper left side of
the platform control box.
The outriggers are used to level the SRT (for com-
plete outrigger operating procedures see the “Op-
eration” chapter 1).
The SRT must be on a firm surface capable of
withstanding all load forces imposed by the
aerial platform in all operation conditions
before the outriggers are used.
■ RCD / ELCB Outlet
The RCD (Residual Current Device) is located at
the ground and will protect against short circuits to
earth. When there is a short circuit the RCD will
shut down the 230v AC power to the platform outlet.
To reset the outlet disconnect the power tool lead
from the platform box and reset the RCD at the
ground.
If the problem persists call a trained service techni-
cian.
■ Flashing Light
The flashing light alerts people that the SRT is
present and that the SRT is moving. The light
flashes at about one flash per second any time the
SRT is running. There is no ON/OFF switch for the
flashing light, it cannot be turned off while the SRT
is running.
SRT2670 – 11360A page 11 - 1