Snorkel SRT2670 - Manual (Page 59)

4. Pull and hold the Outrigger switches (4)
backward, one at a time, until all four
outrigger pads (1) contact the ground.
Death or serious injury can result if an SRT
tips over. Do not use the outriggers to gain
extra working height, they are not designed for
that purpose. At least one of the outriggers
should raise the SRT less than six inches (15
cm) above the ground — use the other three
outriggers to level the SRT as necessary.
5. Visually check the bubble level (5) to
determine which outriggers must be
further extended to level the platform (3).
When the bubble (6) in the bubble level is in
the center of the ring (7), the platform is level.
If the platform is up and the ground
compresses unevenly under different outrigger
pads the SRT might fall over causing serious
injury or death. Check the bubble level (5)
frequently during operation. If any movement
of the bubble (6) occurs, completely lower the
platform immediately and readjust the
outriggers to re-center the bubble (6) in the
ring (7).
6. Lower the appropriate outriggers just
enough to center the bubble (5). When
the Lift Indicator Light (8) comes on, the
platform can be safely raised.
❑ To raise the outriggers:
1. Completely lower the platform.
2. Push and hold the Outrigger switches (9)
forward until all the outriggers are
completely up.
The LIFT function will not work unless the
outriggers are completely up.
SRT2670 – 11360A page 8 - 9
8. Operation
DANGER
6
5
7
DANGER