Snorkel SRT2670 - Manual (Page 17)

2. Safety Devices
■ Safety Device Information
For emergency operation controls and procedures
see the “Emergency Operation” chapter 9, in this
manual.
The devices listed in this chapter are safety de-
vices.
They are on an SRT to increase safety in the work
place for both the operator and other people near
the machine.
Do not by-pass, disable, modify, or ignore any
of these devices. Check them carefully at the
start of each work shift to see that they are in
working order (see “Daily Inspection &
Maintenance” chapter7). If any is found to be
defective, remove the SRT from service
immediately until a qualified service technician
can make repairs.
■ Emergency Stop Switches
❑ At platform control box
Press the large red EMERGENCY STOP button in
and the entire machine stops, the engine turns off,
and nothing moves. This switch must be out (on) to
control the SRT from the platform (turn the switch
clockwise and it will pop out.
❑ At ground control box
Press the red EMERGENCY STOP switch cover
down, at any time, under any conditions, and the
entire machine stops, the engine turns off, and
nothing moves. the EMERGENCY STOP switch
must be up for anything on the SRT to work.
■ Alarms
❑ Platform control box
There are two alarms on an SRT. One is located in
the platform control box, the other is located in the
ground control box.
SRT2670 – 11360A page 2 - 1
CAUTION