Snorkel SRT2670 - Manual (Page 39)

7. Daily Inspection and Maintenance
At the start of each work day (or 8 hour shift), an
SRT qualified operator must perform the Daily In-
spection and Maintenance as listed in the table be-
low.
The purpose of the Daily Inspection and Mainte-
nance is to keep the SRT in proper working condi-
tion and to detect signs of malfunction at the
earliest possible time.
Set the Key Switch set to OFF before you begin
this inspection.
Defective parts and/or equipment malfunctions
jeopardize the safety of the operator and other per-
sonnel, and can cause damage to the machine.
DO NOT operate an SRT that is known to be
damaged or malfunctioning.
Repair all equipment damage or malfunctions,
before placing the SRT into service.
SRT2670 – 11360A page 7 - 1
Item Service Required
Fuel level Visually inspect
Fuel filter (diesel engines only) Visually inspect (condition)
Fuel leaks Visually inspect (hoses and connections etc)
Engine oil Check oil level (between dipstick lines)
Engine coolant Check fluid level and radiator hoses
Radiator cap Visually inspect installation)
Platform safety chain Visually inspect (operation)
Swinging gate Visually inspect (installation, operation)
Wiring harnesses and connectors Visually inspect (installation, operation)
Battery terminals Visually inspect (no corrosion)
Hydraulic tank cap Visually inspect installation)
Hydraulic oil level Check fluid level (at line on side of tank)
Hydraulic oil leaks Visually inspect (hoses,tubes)
Tires and wheels Visually inspect (condition)
Bolts and fasteners Visually inspect (looseness)
Structural damage and welds Visually inspect (welds, cracks, dents)
Guardrails Visually inspect (condition)
Lanyard anchorages (option) Visually inspect (condition)
Bubble level on platform (outrigger machines) Visually inspect (condition)
Guides, rollers and slides Visually inspect (condition)
START THE ENGINE FROM THE GROUND CONTROL BOX
Charging system Check condition (gauge)
Level sensor Check operation
Ground controls Actuate and visually inspect for operation
Emergency lowering Check operation (causes correct motion)
Platform controls Actuate and visually inspect for operation
Flashing light (option) Visually check (operation)
RCD / ELCB (option) Check operation
Air filter Check condition (gauge)
Safety prop Check operation
Parking brakes Check operation
Placards, decals, and Operators Manual Visually inspect (installation and condition)
■ Daily Inspection and Maintenance Table
DANGER