Snorkel SRT2670 - Manual (Page 11)

1. Safety
■ Safe Operation
The following safety information is vitally important
for safe operation of the SRT. Failure to follow these
instructions can result in personal injury or DEATH.
❑ Pre-start Inspection
At the start of each work shift, the SRT shall be
given a visual inspection and function test. See the
“Daily Inspection and Maintenance” chapter 7, in
this manual for a list of items to inspect and test.
DO NOT operate the SRT unless you are
trained and authorized, understand the
operation characteristics of the SRT, and have
inspected and tested all functions to be sure
they are in proper working order.
❑ Work Place Inspection and Practices
Do not use the SRT as a ground for welding.
Ground to the work piece.
Before the SRT is used, and during use, check the
area in which the SRT is to be used for possible
hazards such as, but not limited to:
1. Drop-offs or holes.
2. Side slopes.
3. Bumps and floor obstructions.
4. Debris.
5. Overhead obstructions and electrical
conductors.
6. Hazardous locations.
7. Inadequate surface and support to
withstand all load forces imposed by the
aerial platform in all operating
configurations.
8. Wind and weather conditions.
9. Presence of unauthorized persons.
10. Other possible unsafe conditions.
Before the SRT is used, determine the hazard clas-
sification of any particular atmosphere or location
according to ANSI/NFPA 505-1987.
Any SRT operated in a hazardous location must be
approved and of the type required by ANSI/NFPA
505-1987.
A recommended safety practice is to have person-
nel that are trained in the operation of the emer-
gency controls working in the immediate area of the
SRT to assist the platform operator in the event of
an emergency.
When moving the platform, check the clearance
around the SRT to avoid contact with structures or
other hazards. Always look in the direction of mo-
tion.
Keep ground personnel from under the platform
when the platform is raised.
Secure all accessories, containers, tools, and other
materials in the platform to prevent them from acci-
dentally falling or being kicked off the platform.
DO NOT engage in any form of “horseplay” or “stunt
driving” while operating the SRT.
DO NOT permit riders on the machine anyplace
other than on the platform.
Remove all loose objects stored in or on the ma-
chine, particularly in the platform. Remove all ob-
jects which do not belong in or on the machine.
When other moving equipment is in the area, take
special precautions to comply with local regula-
tions regarding warnings.
Never steady the platform by positioning it against
another platform.
DO NOT operate an SRT that is not functioning
properly, or has been damaged, until the machine
has been repaired by a qualified maintenance per-
son.
DO NOT operate a SRT that does not have all its
decals and placards attached and legible.
Drive the machine with care and at speeds compat-
ible with conditions. Use extra caution when driving
over rough ground, on slopes, and when turning.
Know and understand the job site traffic-flow pat-
terns and obey the flagmen, road signs, and sig-
nals.
Watch for bystanders and never allow anyone to be
under, or to reach through, the machine and its
equipment while operating.
Use the recommended transport device when
loading the machine.
SRT2670 – 11360A page 1 - 1
CAUTION