Lull 1044C-54 Series II Service Manual - Manual (Page 167)

Boom and Transfer
31200079 6-25
Removal
Rear Carriage Tilt Cylinder
Fig. 6-14: Rear Carriage Tilt Cylinder Installation
(Ref. Fig. 6-14) The following steps are required to remove rear carriage
tilt cylinders.
1. Follow preparation procedures as outlined in Section 3.
2. Lower the boom to the ground, apply the park brake, retract the
cylinder, and stop the engine.
1
J
1129
# Description
1 Outer Boom
2 Lock Pin
3 Lockwasher
4 Hex Head Capscrew
5 Cylinder Pivot Pin - Rod End
6 Rear Carriage Tilt Cylinder
7 Hydraulic Hose
# Description
8 Grease Fitting Cover
9 Grease Fitting
10 Lock Pin
11 Lockwasher
12 Hex Head Capscrew
13 Cylinder Pivot Pin - Base End
14 Transfer Carriage/Boom Cradle
2 3
4
5
7 6
13
12
11
10
8
9
14