Lull 1044C-54 Series II Service Manual - Manual (Page 161)

Boom and Transfer
31200079 6-19
Removal
Front Carriage Tilt
Cylinder
Fig. 6-11: Front Carriage Tilt Cylinder Installation
(Ref. Fig. 6-11) The following steps are required to remove the front
carriage tilt cylinder.
1. Remove quick attach assembly. See page 6-44
2. Tag and disconnect two (2) hydraulic hoses (Item 6) from connectors
(Item 8). Cap fittings and hoses.
3. Support cylinder (Item 7) with sling(s) and crane, or other suitable
means. Make sure equipment has sufficient capacity to support weight
of cylinder; the cylinder weighs approximately 200 pounds.
J
1
070
6
5
1
2
3
4
7
8
# Description
1 Inner Boom Section Pin Boss
2 Lock Pin
3 Lockwasher
4 Capscrew
# Description
5 Upper Pivot Pin
6 Hydraulic Hose
7 Front Carriage Tilt Cylinder
8 O-ring Connector