Apple Logic Express 8 - Manual (Page 360)

360 Chapter 13 Creating Your Arrangement
To adjust the fade curve shape:
m Hold Control and Shift while using the Crossfade tool.
In the example below, a positive Curve is shown for both the fade in and fade out.
In the example below, a negative Curve is shown for the fade in, and a linear fade (no
curve) is shown for the fade out.
Creating and Modifying Fades in the Region Parameter Box
You can also create and edit fades in the Region Parameter box.
To create a fade or crossfade:
1 Select the desired regions.
2 Set the desired value for the Fade In or Fade Out setting in the Inspector. Use the
mouse as a slider, or double-click and type in the desired value.
As you do so, a fade is created at the beginning or end of the selected regions.
Note: The fade value determines the length of the fade, so a higher value results in a
longer fade time, and a low value, a short fade.
To delete a fade:
m Set the Fade In or Fade Out parameter to 0.
To change an existing fade:
m Edit the Fade In or Fade Out value.