Apple Power Macintosh 7600/200 Series - Manual (Page 201)

The Custom Install dialog box appears, listing all available system
software components.
13 Make sure that the hard disk named in the Destination Disk box is the one on which you
want to install system software.
If it isn’t, click Switch Disk until the correct disk name appears.
14 Scroll through the list of components, clicking the checkbox next to each component
you want to install.
To get additional information about each component listed, click the box with
the letter i in it to the right of the component.
15 Click Install.
16 Follow the instructions that appear on the screen.
17 When you see a message reporting that the installation was successful, click Quit.
If a message reports that installation was not successful, try installing again.
(Follow the instructions on the screen.)
18 Restart your Macintosh.
The system software is installed and your computer is ready to use. Don’t
forget to eject the CD-ROM disc containing system software when you
are finished.
201 Diagnostic Techniques