Apple Power Macintosh 7600/200 Series - Manual (Page 17)

m If you connected an ADB cable between the monitor and the computer, is
it attached firmly to the ports marked with V icons? (Don’t connect or
disconnect this cable while the computer is on. You could damage your
equipment. To turn off your computer, press the power button on its front
panel.)
m Is the monitor power cord plugged in?
m Is the monitor cable—the one connected to the monitor port (™) on your
computer—attached firmly to both the monitor and computer?
m Is the monitor turned on? (Check the power-on light on the front of
the monitor.)
m Is the brightness control on the monitor adjusted correctly? (On most
monitors, the brightness control is marked with the symbol ¤.)
m Is the computer asleep? To wake the computer, press the Power key
(marked with a π) on the keyboard. It may take a moment or two for the
computer to wake up.
m If you see a blinking question mark, see Chapter 9, “Start Here If
Trouble Occurs.”
What’s next?
Congratulations—you’ve finished setting up your computer. If this is the first
time you’ve used a Macintosh computer, turn to Chapter 2, “Learning to Use
Your Computer.”
If you already know how to use a Macintosh computer, continue with the next
section, “Where to Find Answers.”
IMPORTANT If you want to turn off your computer, be sure to follow the
proper shutdown procedure explained at the end of Chapter 2, “Learning to
Use Your Computer.”
17 Setting Up Your Computer