Apple Logic Express 7 - Manual (Page 48)

48 Chapter 6 Filter
AutoWah Attack/Release
These parameters allow you to define how much time it takes for the Wah filter to open
and close. Range (in milliseconds): 10 to 10,000
Comp Ratio
The Comp Ratio of the integrated compressor can be adjusted between 1:1 (no
compression) and 30:1. The Compressor is tied to the Fuzz effect, and always precedes
it. As such, the FX Order parameter is very important for placement of the Compressor
in the effects chain.
Fuzz Gain
Controls the level of Fuzz (distortion). Range: 0 dB to 20 dB.
Fuzz Tone
The integrated Fuzz effect can be adjusted, tonally, with this parameter. Range: 2000 Hz
to 20,000 Hz
High Cut/Low Cut
• The Low Cut filter attenuates the frequency range below the selected frequency.
• The High Cut filter attenuates the frequency range above the selected frequency.
High Pass/Low Pass Filter
• The High Pass Filter affects the frequency range below the set frequency. Higher
frequencies pass through the filter. You can use the High Pass Filter to completely get
rid of the bass range below a selectable frequency.
• The Low Pass Filter affects the frequency range above the selected frequency. Lower
frequencies pass through the filter. You can use the Low Pass Filter to completely get
rid of the treble range above a selectable frequency.