Apple Macintosh PowerBook 190 Series - Manual (Page 64)

Connecting SCSI devices
A SCSI device is any product—including hard disk drives, CD-ROM drives,
and scanners—that communicates with your computer by means of a
standard electronic interface. (SCSI stands for Small Computer System
Interface.) You can attach up to 6 SCSI devices to your computer by linking
them together in a chain that starts at your computer’s SCSI port.
To connect a SCSI device to your Macintosh PowerBook, you need an Apple
HDI-30 SCSI System Cable or equivalent. This cable is light gray (the same
color as desktop Macintosh computers), is about 19 inches long, and has 29
pins (one “missing” pin).
Refer to the manuals that came with your SCSI devices for instructions on
installing any necessary software, setting SCSI ID numbers, and connecting
SCSI cables and SCSI terminators. Refer to the illustrations below for the
proper positioning of SCSI terminators. A SCSI chain of devices must include
a terminator attached to the first and last devices in the chain (but nowhere
else in the chain). Some devices include internal terminators. Your Macintosh
PowerBook is not internally terminated.
The names and the part numbers of the cables mentioned in this chapter are
the following:
Type of connection Name of cable Part number
From your computer to Apple HDI-30 SCSI System Cable M2538LL/A
a SCSI device
From SCSI device to Apple SCSI Peripheral Interface Cable M0207
a SCSI device
For SCSI disk mode Apple HDI-30 SCSI Disk Adapter Cable M2539LL/A
To connect an PowerBook Video Adapter Cable M3927LL/A
external monitor
WARNING When connecting SCSI equipment, always turn off power to
all devices in the chain, including your computer. If you don’t, you
could lose information and damage your equipment.
54 Chapter 4