J.P. Instruments EDM 700/800/711 Pilots Guide - Manual (Page 61)

For Your Safe Flight Page 57
Filled Tanks
In flight, do this first (on power up,
skip to step 4):
1.
Hold both STEP and LF until
the display shows
PROGRAM,
followed by FUEL? N.
2. Tap LF to see FUEL? Y.
3. Tap STEP
4. See FILL? N. Tap LF to see
FILL 75*
5. With aux tanks or tabs, tap LF
again to see
FILL I20*
6. Tap STEP to exit.
Added or Removed Fuel
In flight, do this first (on power up,
skip to step 4):
1.
Hold both STEP and LF until
the display shows
PROGRAM,
followed by FUEL? N.
2. Tap LF to see FUEL? Y.
3. Tap STEP.
4. See FILL? N. Tap LF 2 or 3 times
to see FILL+.
5. Tap STEP and see .0GAL.
6. Hold LF to increase or tap LF
to decrease the amount of fuel
displayed.
7. Tap STEP to exit.
Reset Alarm (except EDM-711)

Temporary reset (next 10
minutes): tap STEP.

Reset for remainder of flight:
hold STEP until the word
OFF
appears.
Leaning Rich of Peak
1. Pre-lean mixture and wait 1
minute.
2. Tap LF and see LEANR.
3. Lean mixture until you see a
column flash and the words
LEANEST followed by
I545SET*
4. Hold LF and see I560PK*or
I560 I3.5*, the peak EGT of the
first cylinder to peak and fuel
flow.
5. Enrich mixture to set desired
temperature.
Leaning Lean of Peak
1. Pre-lean mixture and wait 1
minute.
2. Tap LF and see LEANR.
3. Hold both STEP and LF until
you see
LEANL
4. Lean mixture until inverted
columns.
5. Continue leaning until you see
a column flash. You will see
the temperature below peak of
the last cylinder to peak and
the fuel flow.
6. Hold LF to see I560 I.0* to see
peak EGT of the first cylinder
to peak and the delta fuel flow
(GAMI spread).
7. Lean mixture to set desired
temperature.
* Values will vary depending on your
individual installation.