J.P. Instruments EDM 700/800/711 Pilots Guide - Manual (Page 31)

For Your Safe Flight Page 27
Refer to the flow chart. Then tap the STEP button to complete the entry
and advance to the Manual mode.
Adding Fuel and Auxiliary Tanks
If you either
a) added less than full fuel to only
the main tanks, or
b) topped the main tanks but have
some fuel remaining in the
auxiliary tanks,
then select FILL + and the next display
will ask you how much you added: .0 GAL
(or selected units). Hold the LF button to
count up, tap the LF button to count
down. The count up will stop at full
tanks, since you cannot add more fuel
than would top the tanks.
If you added fuel to only the main tanks,
then input how much you added.
If you topped the main tanks, but have
some fuel remaining in the auxiliary
tanks, input how much is now in the
auxiliary tanks.
You can “add” a negative amount of fuel
if you remove fuel from the aircraft or
wish to correct the total quantity of fuel on board.
Accumulate Total—Trip Total
You may either display total fuel used since the last time you informed
the EDM that the aircraft was refueled, or for an extended trip with
multiple fuel stops. This selection affects only the
USD parameter. How
to select whether to accumulate or reset is described in “Pilot
Programming” beginning on page 33.
Resetting “USED”
Every time you inform the EDM that the aircraft is refueled, the amount
of fuel used is set to zero, unless the instrument is programmed to
accumulate. The display of fuel used pertains only to the fuel used since
the last time you informed the EDM that the aircraft was refueled.
Power up
FUEL ?N
Pgm Refuel
Program
FILL ?N
FILL ?75 *
Yes Change
Fill ?+
OK Start
Exit Fill
.0 GAL
Done +/-
FILL ?120 *
Yes Add
STEP LF
STEP LF
STEP LF
STEP LF
STEP LF
STEP LF