J.P. Instruments EDM 700/800/711 Pilots Guide User Manual
Page 60
Page 56
Engine Data Management
Quick Reference Guide
Normalize View
Hold LF for three seconds.
Percentage View
Hold LF for three seconds.
Automatic Scan
1.
Tap LF.
2.
Tap STEP.
Exclude Parameter in Automatic
Scan (except EDM-711)
1.
Tap STEP to index to the
parameter to exclude.
2.
Tap both STEP and LF.
3.
See decimal point before
parameter name to exclude.
Change Indexing Rate
1.
Hold both STEP and LF until
the display shows
PROGRAM,
followed by
FUEL? N.
2.
Tap STEP and see
RATE 4.
3.
Tap LF to change the number:
1 through 9 is the pause time
during automatic indexing.
0 sets to never index (except
EDM-711).
4.
Tap STEP until you see
END Y,
then tap STEP to exit
Mark Data in Memory
Tap LF twice.
Reset Fuel Used to zero in flight
1.
Tap STEP and see
USD.
2.
Hold both STEP and LF until
the display shows
.0USD
Transfer Data in Memory
1.
Connect PC Computer to the
EDM serial port.
2.
Hold both STEP and LF until
the display shows
PROGRAM,
followed by
FUEL? N.
3.
Tap STEP a few times until
you see
DUMP? N.
4.
Tap LF until you see
DUMP NEW
or
DUMP ALL.
5.
On the PC Computer click on
the Start button
6.
On the EDM tap STEP to
transfer. (to abort hold STEP
and LF for 5 seconds).
7.
On the EDM see
SAVED?N.
8.
If save was successful, tap LF
to see
SAVED?Y.
9. Tap STEP to exit.
Initially Entering Tank
Capacity
To initialize or change the tank
capacities, hold the STEP
button while turning on the
power to the EDM. The
following program steps will be
displayed:
MAIN=50
Main tank capacity,
in units selected
AUX? N
Y—Yes—aircraft
has auxiliary tanks
AUX=0
Auxiliary tank
capacity
Tap STEP to advance to the
next item.
Hold LF to increase or
tap LF to change the amount.