Mueller Pre-Fab - Manual (Page 75)

www.muellerinc.com F-1
flasHInG, GUTTeR anD TRIM
The correct installation of flashing, gutters, and trim cannot be overemphasized . The overall
appearance of the finished building depends primarily on the quality of the installation of the
flashing, gutters and trim . Keep all gutter and flashing lines straight . Make all bends sharp and
neat . Be sure edges are not jagged, dented, crimped, or serrated . End joints and laps must be
closely controlled .
Wall Panel
Peak Box
Rake
Trim
Rake
Angle
Gutter
Ridge Roll
Flashing
Peak Sheet
Ridge
Eave Trim
noTe: flashing should be stored off the ground to avoid moisture and handling
damage. elevate one end of the package above the lower end to encourage
drainage in case of rain. always wear gloves when handling sheet metal.
WaRnInG! Mueller trim comes with a protective film coating to aid in the
prevention of scuffing. Do not allow this film to be exposed to te sun. exposure
will bond the film to the metal making removal difficult.