Mueller Pre-Fab - Manual (Page 18)

877-2-MUELLER B-6
Wall anD Roof Panels (continued)
storage:
It is recommended that sheets be stored under roof if at all possible . If sheets are to be stored
outside, the following precautions should be observed:
1 . The storage area should be reasonably level, and located so as to minimize handling .
2 . When stored on bare ground, place a plastic ground cover under the bundles to minimize
condensation on the sheets from ground moisture .
3 . Store bundles at least 12 inches above ground level to allow air circulation beneath the
bundle, and to prevent damage from rising water .
4 . Elevate one end of each bundle slightly to permit runoff of moisture from the top of the
bundle or from between sheets . A waterproof cover should be placed over the bundles to
allow for air circulation under the cover .
5 . Inspect stored bundles daily and repair any tears or punctures in the waterproof cover .
6 . Re-cover opened bundles at the end of each workday to prevent subsequent
moisture damage .
checking order at Time of Delivery
Check each order carefully, as it is unloaded . Report any obvious damage or shortages to the
carrier immediately . If damage or shortages are noted after delivery (at time of unpacking) notify
your Mueller representative immediately . Have invoice numbers and detailed descriptions of the
damage or shortage available . These procedures are for your protection . A shortage or damage
discovered later, can be caused by theft, misplacement, mishandling or other causes and is not
the responsibility of Mueller, Inc .
Drainage
Elevate
Air Circulation
neveR InsTall MaTeRIal If THe QUalITY Is In QUesTIon!