Pump and gearbox assembly, Removing pump assembly from apparatus – Hale SMR User Manual
Page 85
Stainless Max Series Pumps
6-7
Maintenance and Repair
❑
Ball peen hammer
❑
Center punch
❑
Drift punch
❑
Allen wrenches
❑
Strap wrench
❑
Snap ring pliers
❑
Pry bars (2)
❑
Ratchets and wrenches for disassembly
❑
Torque wrench, capable of 40, 65, and 135 ft.-lb. (54, 88, and
183 N-m)
❑
Pan (to collect drip oil)
❑
Disposable rags
❑
Oil dry
❑
Wood wedges
❑
Bearing puller
❑
Pusher tube (a small section of PVC tubing to fit over the shaft)
PUMP AND GEARBOX ASSEMBLY
WARNING !
THE SM SERIES PUMP AND GEARBOX ARE HEAVY AND BULKY,
WEIGHING UP TO 750 TO 850 LBS. / 340 TO 386KGS (APPROXIMATE).
BE CERTAIN TO USE PROPER LIFTING SUPPORT DEVICES CAPABLE
OF HANDLING THE LOAD WHEN REMOVING OR INSTALLING SM
SERIES PUMP AND GEARBOX ASSEMBLIES.
The following procedures frequently refer to Tables 6-1, 6-2 and 6-3 on
page 6-2. Also, please review the General Repair and Cleaning and
Inspection Guidelines before beginning these procedures.
Removing Pump Assembly from Apparatus
1. First, review preceding section “Before You Begin...,” beginning
on page 6-1.
2. With the pump assembly properly supported and balanced,
disconnect the mounting brackets that secure the pump and
gearbox assembly to the apparatus.
3. Carefully remove the assembly from the apparatus.