Brother HL 5370DW - Manual (Page 29)

Configuring your machine for a wireless network (For HL-5370DW)
19
3
Wireless network terms and concepts
3
If you want to use your machine in a wireless network you must configure the machine to match the
settings of the existing wireless network. This section provides some of the main terms and concepts of
these settings, which may be helpful when you configure your machine for a wireless network.
SSID (Service Set Identifier) and channels
3
You need to configure the SSID and a channel to specify the wireless network you want to connect to.
SSID
3
Each wireless network has its own unique network name and it is technically referred to as SSID or ESSID
(Extended Service Set Identifier). The SSID is a 32-byte or less value and is assigned to the access point.
The wireless network devices you want to associate to the wireless network should match the access point.
The access point and wireless network devices regularly send wireless packets (referred to as a beacon)
which has the SSID information. When your wireless network device receives a beacon, you can identify the
wireless network that is close enough for the radio waves to reach your device.
Channels
3
Wireless networks use channels. Each wireless channel is on a different frequency. There are up to 14
different channels that can be used when using a wireless network. However, in many countries the number
of channels available are restricted. For more information, see Wireless network (for HL-5370DW) on
page 187.
Authentication and encryption
3
Most wireless networks use some kind of security settings. These security settings define the authentication
(how the device identifies itself to the network) and encryption (how the data is encrypted as it is sent on the
network). If you do not correctly specify these options when you are configuring your Brother wireless
device, it will not be able to connect to the wireless network. Therefore care must be taken when
configuring these options. Please refer to the information below to see which authentication and encryption
methods your Brother wireless device supports.
Authentication methods
3
The Brother machine supports the following methods:
„ Open System
Wireless devices are allowed to access the network without any authentication.
„ Shared Key
A secret pre-determined key is shared by all devices that will access the wireless network. The Brother
machine uses the WEP keys as the pre-determined key.