Brother HL 5370DW - Manual (Page 191)

Appendix
181
A
Using ARP to configure the IP address
0
If you are unable to use the BRAdmin application and your network does not use a DHCP server, you can
also use the ARP command. The ARP command is available on Windows
®
systems that have TCP/IP
installed as well as UNIX systems. To use arp enter the following command at the command prompt:
arp -s ipaddress ethernetaddress
Where ethernetaddress is the MAC Address (Ethernet Address) of the print server and ipaddress is
the IP address of the print server. For example:
„ Windows
®
systems
Windows
®
systems require the dash “-” character between each digit of the MAC Address (Ethernet
Address).
arp -s 192.168.1.2 00-80-77-31-01-07
„ UNIX/Linux systems
Typically, UNIX and Linux systems require the colon “:” character between each digit of the MAC Address
(Ethernet Address).
arp -s 192.168.1.2 00:80:77:31:01:07
Note
You must be on the same Ethernet segment (that is, there cannot be a router between the print server and
operating system) to use the arp -s command.
If there is a router, you may use BOOTP or other methods described in this chapter to enter the IP address.
If your Administrator has configured the system to deliver IP addresses using BOOTP, DHCP or RARP your
Brother print server can receive an IP address from any one of these IP address allocation systems. In
which case, you will not need to use the ARP command. The ARP command only works once. For security
reasons, once you have successfully configured the IP address of a Brother print server using the ARP
command, you cannot use the ARP command again to change the address. The print server will ignore any
attempts to do this. If you wish to change the IP address again, use Web Based Management (web
browser), TELNET (using the SET IP ADDRESS command) or factory reset the print server (which will then
allow you to use the ARP command again).
To configure the print server and to verify the connection, enter the following command ping ipaddress
where ipaddress is the IP address of the print server. For example, ping 192.189.207.2.