Brother FAX-8350P - Manual (Page 47)

37
I N I T I A L S E T U P
Setting the Speaker Volume
You can adjust the speaker volume when your machine has dialled
(onhook dialling) and the line is connected. You can turn the volume OFF
or you can select a volume level.
Press or to adjust the volume level. The display shows the setting
you are choosing.
Each key press changes the volume to the next setting. The new setting
will remain until you change it again.
Setting the Ring Volume
You can adjust the ring volume when your machine is idle. You can turn
the ring OFF.
Press or to adjust the volume level. With each key press, the
machine rings so you can hear the current setting and the display shows
the setting you are choosing.
Each key press changes the volume to the next setting.
The new setting will remain until you change it again.
Memory Storage
In the event of a power failure, all settings in the INITIAL SETUP,
SETUP RECEIVE, SET QUICK-DIAL and REMOTE FAX OPT,
plus the COVERPG SETUP and COVERPAGE NOTE (from SETUP
SEND) functions are stored permanently.
Memory Security
(Only for FAX-8350P/FAX-8750P)
This feature allows you to prevent unauthorised access to the fax
machine. When switched ON, Memory Security prohibits most
functions. The following functions listed are available while Memory
Security is switched ON.
■ Receiving faxes into memory [limited by Memory Capacity].
■ Scheduled Delayed Transmission*
■ Polling*
■ Fax Forwarding*
■ Remote Retrieval
* Provided it was set before Memory Security was switched ON.