Nokia N86 8MP - Manual (Page 139)

Slide handling settings
Select Menu > Tools > Settings and General >
Slide handling .
Select from the following:
● Opening the slide — Set the device to answer an
incoming call when you open the slide.
● Closing the slide — Set the device to end an active
call when you close the slide.
● Keyguard activation — Set the device to lock the
keypad when you close the slide.
Sensor settings and display
rotation
When you activate the sensors in your device, you can
control certain functions by turning the device.
Select
Menu > Tools > Settings and General >
Sensor settings .
Select from the following:
● Sensors — Activate the sensors.
● Turning control — Select Silencing calls and
Snoozing alarms to mute calls and snooze alarms
by turning your device so that the display faces
down.
Security settings
Phone and SIM
Select Menu > Tools > Settings and General >
Security > Phone and SIM card and from the
following:
● PIN code request — When active, the code is
requested each time the device is switched on.
Deactivating the PIN code request may not be
allowed by some SIM cards.
● PIN code , PIN2 code , and Lock code — You can
change the PIN code, PIN2 code, and lock code.
These codes can only include the numbers from 0 to
9.
If you forget the PIN or the PIN2 code, contact your
service provider. If you forget the lock code, contact
a Nokia Care point or your service provider.
Avoid using access codes similar to the emergency
numbers to prevent accidental dialing of the
emergency number.
● Keypad autolock period — Select whether the
keypad is locked when your device has been idle for
a certain period of time.
● Phone autolock period — To avoid unauthorized
use, you can set a time-out after which the device
automatically locks. A locked device cannot be used
until the correct lock code is entered. To turn off the
autolock period, select None .
139
Se
ttings