Nokia 7610 - Manual (Page 57)

44 Copyright © 2004 Nokia
Messaging options are Create message , Connect (shown if you have defined settings
for the mailbox) or Disconnect (shown if there is an active connection to the
mailbox), SIM messages , Cell broadcast , Service command , Settings , Help , and Exit .
• WRITE TEXT
You can key in text in two different ways, using the method traditionally used in
mobile phones or another method called predictive text input.
Traditional text input
The indicator is shown on the top right of the display when you are writing
text using traditional text input.
Press a number key (1–9), repeatedly until the desired character appears. Note that
there are more characters available for a number key than are printed on the key.
Icons: and indicate the selected case. means that the first
letter of the next word is written in upper case, and all other letters will automatically
be written in lower case.
indicates number mode.
To insert a number, press and hold the corresponding number key.
To switch between letter and number mode, press and hold the # key.
If the next letter is located on the same key as the present one, wait until the cursor
appears (or scroll right to end the time-out period), and key in the letter.
If you make a mistake, press the Clear key to remove a character. Press and hold
the Clear key to clear more than one character.
Reports (network service)—You can request that the network send you
a delivery report of the text messages, smart messages, and multimedia
messages you have sent. To turn on delivery report reception, go to the
Messaging main menu, select Options > Settings > Text message
or
Multimedia message, and select Receive report > Yes.
It might not be possible to receive a delivery report of a multimedia
message that has been sent to an e-mail address.
Note: When sending messages, your device may display the
words Message Sent. This is an indication that the message has
been sent by your device to the message center number
programmed into your device. This is not an indication that the
message has been received at the intended destination. For more
details about messaging services, check with your service provider.
Before you create a multimedia message, write an e-mail, or connect to
your remote mailbox, you must have the correct connection settings in
place. See "Write and send messages" on page 47. See "Settings needed
for multimedia messaging" on page 48.