Toshiba Equium 8000 S-D - Manual (Page 47)

3-6 Hardware for the Toshiba Equium™ 8000S User's Manual
(TXLXP 8VHU V 0DQXDO ± &+$3'2& ± (1*/,6+ ± 3ULQWHG RQ DV B8.
7. Unpack your device kit and check that it is complete.
8. Follow the device manufacturer’s instructions to configure the new
device’s jumpers so that it will act as a master device, and connect it
to the cable which had been attached to the device you are
replacing.
9. Insert and fasten the new device into its chassis location by snapping
it into place.
10. Connect the new device to the IDE connector identified in step 4
above.
11. Connect the new device to the power supply connector identified in
step 5 above.
12. Replace the case.
Configuring the new device
Before you can use a new device, it must be configured. Your Microsoft
operating system may be able to configure the new device automatically
when you reboot the computer.
If the device is not automatically configured by the operating system,
you may need to use the BIOS Setup program to manually configure the
device. Information about your computer’s BIOS is available from
Toshiba’s online customer support at www.support.toshiba.com.
To determine which configuration settings to use for the new device,
refer to the documentation that came with the device.
Write down the device type and settings of your existing devices for
future reference, or in case you inadvertently change this information
while manually configuring the new device.
Partitioning and formatting a new hard disk drive
Before you can use the new hard disk drive, it must be partitioned and
formatted. Follow the instructions provided by the manufacturer.
Take care not to accidentally format your existing drive. Formatting
destroys all data on a drive.