beautypg.com

S7 connection completion time-out, S8 comma pause time, S11 dtmf dialling speed – Toshiba Satellite 2430-301 User Manual

Page 191

background image

S-registers

Satellite 2430 Series

I-4

Satellite 2430 Series

Version

1

Last Saved on 04/04/2003 13:35

ENGLISH using Euro_M.dot –– Printed on 04/04/2003 as IM_243EN

S7

Connection completion time-out

This register sets the time, in seconds, that the modem must
wait before hanging up because carrier is not detected. The
timer is started when the modem finishes dialling (originate), or
goes off-hook (answer). In originate mode, the timer is reset
upon detection of an answer tone if allowed by county
restriction. The timer also specifies the wait for silence time for
the @ dial modifier in seconds. S7 is not associated with the W
dial modifier.
Range: 1-255
Default: 50
Units: seconds

S8

Comma pause time

This register sets the time, in seconds, that the modem must
pause when it encounters a comma (,) in the dial command
string. In some countries, S8 will set both wait before dialling
and comma pause time.
Range: 0-65
Default: 4
Units: seconds

S10 Automatic disconnect delay

This register sets the length of time, in tenths of a second,
that the modem waits before hanging up after a loss of
carrier. This allows for temporary carrier loss without
causing the local modem to disconnect.

The actual interval the modem waits before disconnection is the
value in register S10.
Range: 1-254
Default: 20
Units: .1

seconds

S11 DTMF dialling speed

This register determines the dialling speed which is prefixed for
each country.
Range: 50-150
Default: 85 or 150
Units: .001

seconds

This manual is related to the following products: