beautypg.com

Wireless lan – Toshiba Satellite 2430-301 User Manual

Page 143

background image

Troubleshooting

Satellite 2430 Series

8-19

Satellite 2430 Series

Version

1

Last Saved on 04/04/2003 13:35

ENGLISH using Euro_M.dot –– Printed on 04/04/2003 as IM_243EN

Problem Procedure

A

CONNECT display is

quickly replaced by
NO CARRIER

Check the error control setting in your
communications application.

You can also use the AT\N command. Refer to
Appendix H, AT Commands.

Character display
becomes garbled
during a
communication

In data transmission, make sure the parity bit
and stop bit settings correspond with those of
the remote computer.

Check the flow control and communication
protocol.

You cannot receive an
incoming call

Check the rings before auto answer setting in
your communications application.

You can also use the ATS0 command. Refer to
Appendix I, S-registers.

If problems persist, contact your dealer.

LAN

Problem Procedure

Cannot access LAN

Check for a firm cable connection between the
LAN jack and the LAN HUB.

Wake up on LAN does
not work

Make sure the AC adaptor is connected. You
cannot access a LAN using the computer’s
battery power.

Check the TOSHIBA HW Setup program. The
Wake-up on LAN option of LAN tab should be
set to Enabled.

If problems persist, contact your dealer.

Wireless LAN

If the following procedures do not restore LAN access, consult your LAN
administrator. For more information on wireless communication, refer to
Chapter 4, Operating Basics.

Problem Procedure

Cannot access
Wireless LAN

Make sure the computer’s wireless
communication switch is set to on.

If problems persist, consult your LAN
administrator.

This manual is related to the following products: