Pc cards, Installing a pc card – Toshiba Satellite 2430-301 User Manual
Page 112
Optional Devices
Satellite 2430 Series
7-2
Satellite 2430 Series
Version
1
Last Saved on 04/04/2003 13:35
ENGLISH using Euro_M.dot –– Printed on 04/04/2003 as IM_243EN
PC Cards
The computer is equipped with a PC Card (PCMCIA) expansion slot that
can accommodate two 5 mm Type II cards or one 10.5 mm Type III card.
Any PC Card that meets industry standards (manufactured by TOSHIBA
or other vendor) can be installed. The slots support 16-bit PC Cards,
including PC Card 16’s multifunction card and CardBus PC Cards.
CardBus supports the new standard of 32-bit PC Cards. The bus
provides superior performance for the greater demands of multimedia
data transmission.
If you use a storage device such as a CD-ROM or HDD connected to a 16-
bit PC Card, modem speed might be slow or communication interrupted.
Installing a PC Card
Two PC Card connectors are located one above the other on the right
side of the computer. Both connectors are accessed from the same slot.
You can install two Type II cards, one in each connector, or one Type III
card in the bottom connector.
Windows’ hot-install feature lets you install PC Cards while the
computer’s power is on.
Do not install a PC Card while the computer is in Standby or Hibernation
mode. Some cards might not work properly.
To install a PC Card, follow the steps below.
1.
Insert the PC Card.
2.
Press gently to ensure a firm connection.
Installing a PC Card
After installing the card, refer to the card’s documentation and check the
configuration in Windows to make sure it is appropriate for your card.