Appendix h at commands, Appendix h, At commands – Toshiba Satellite 2430-301 User Manual
Page 173
AT Commands
Satellite 2430 Series
H-1
Satellite 2430 Series
Version
1
Last Saved on 04/04/2003 13:35
ENGLISH using Euro_M.dot –– Printed on 04/04/2003 as IM_243EN
Appendix H
AT Commands
In most cases, you will not need to type AT commands manually.
However, there might be some occasions when you will need to do so.
This chapter describes AT commands for data mode. Fax and voice
commands are taken care of by application software.
The format for entering AT commands is:
ATXn
where X is the AT command, and n is the specific value for that
command. After you type in the command press Enter.
Any command issued is acknowledged with a response in either text or
numeric values known as result codes.
All commands and command-values accepted by the modem are
described in this section; any entry other than those listed results in an
error.
+++ Escape sequence
The escape sequence allows the modem to exit data mode and
enter on-line command mode. While in on-line command mode,
you can communicate directly to your modem using AT
commands. Once you finish, you can return to data mode using
the ATO command.
A pause, the length of which is set by Escape Guard Time (S12),
must be completed after an escape sequence is entered, This
pause prevents the modem from interpreting the escape
sequence as data.
The value of the escape sequence character may be changed
using register S2.
Satellite 2430 Series
User's
Manual
H-1