Xn result code selection, call progress monitoring, Extended result codes, Dial tone detect – Toshiba Satellite 2430-301 User Manual
Page 179: Busy tone detect
AT Commands
Satellite 2430 Series
H-7
Satellite 2430 Series
Version
1
Last Saved on 04/04/2003 13:35
ENGLISH using Euro_M.dot –– Printed on 04/04/2003 as IM_243EN
Xn Result code selection, call progress monitoring
This command sets detection options for dial tones and busy signals,
which is its primary function. It also, however, enables or disables
extended result codes.
Refer to table H-1 for country-specific codes.
Command Extended
result
code
Dial tone
detect
Busy signal
detect
X0
Disable Disable Disable
X1 Enable
Disable
Disable
X2
Enable Enable Disable
X3 Enable
Disable
Enable
X4
(default)
Enable Enable Enable
X5
Enable Enable Enable
X6
Enable Enable Enable
X7 Disable
Enable
Enable
Extended result codes
Disabled: Displays
only
the basic result codes
OK, CONNECT,
RING, NO CARRIER, and ERROR.
Enabled:
Displays basic result codes, along with the connect
message and the modem’s data rate, and an
indication of the modem’s error correction and data
compression operation.
Dial tone detect
Disabled: The modem dials a call regardless of whether it
detects a dial tone. The period of time the modem
waits before dialling is specified in register S6.
Enabled:
The modem dials only upon detection of a dial tone,
and disconnects the call if the dial tone is not
detected within 10 seconds.
Busy tone detect
Disabled: The modem ignores any busy tones it receives.
Enabled:
The modem monitors for busy tones.
Result Codes:
OK n=0,1,2,3,4,5,6,7
ERROR Otherwise