F load factory settings, Gn v.22bis guard tone control, Kn local flow control selection – Toshiba Satellite 2430-301 User Manual
Page 181: Pn select pulse dial make/break ratio (ww)
AT Commands
Satellite 2430 Series
H-9
Satellite 2430 Series
Version
1
Last Saved on 04/04/2003 13:35
ENGLISH using Euro_M.dot –– Printed on 04/04/2003 as IM_243EN
&F Load factory settings
This command loads the configuration stored and programmed
at the factory. This operation replaces all of the command
options and the S-register settings in the active configuration
with factory values.
&F
Recall factory setting as active configuration.
&Gn V.22bis guard tone control
This command determines which guard tone, if any, to transmit
while transmitting in the high band (answer mode). This
command is only used in V.22 and V.22bis mode. This option is
not used in North America and is for international use only.
&G0
Guard tone disabled (default).
&G1
Sets guard tone to 550 Hz.
&G2
Sets guard tone to 1800 Hz.
Result Codes:
OK
n=0,1,2
ERROR Otherwise
&Kn Local flow control selection
&K0
Disables flow control.
&K3
Enables CTS/RTS flow control (default).
&K4
Enables XON/XOFF flow control.
Result Codes:
OK
n=0,3,4
ERROR Otherwise
&Pn Select Pulse Dial Make/Break Ratio (WW)
&P0
Selects 39% - 61% make/break ratio at 10 pulses per
second.
&P1
Selects 33% - 67% make/break ratio at 10 pulses per
second.
&P2
Selects 39% - 61% make/break ratio at 20 pulses per
second.
Result Codes:
OK
n=0 to 2
ERROR Otherwise