beautypg.com

Basic setup, 03 basic setup, Basic setup 03 – Pioneer VSX-2020-K User Manual

Page 23: Chapter 3

background image

Basic Setup

03

23

En

Chapter 3:

Basic Setup

Automatically setting up for surround
sound (Auto MCACC)

The Auto MCACC Setup measures the acoustic
characteristics of your listening area, taking into account
ambient noise, speaker connection and speaker size, and
tests for both channel delay and channel level. After you
have set up the microphone provided with your system,
the receiver uses the information from a series of test
tones to optimize the speaker settings and equalization
for your particular room.

Important

• Make sure the microphone and speakers are not

moved during the Auto MCACC Setup.

• Using the Auto MCACC Setup will overwrite any

existing settings for the MCACC preset you select.

• Before using the Auto MCACC Setup, the

headphones should be disconnected.

CAUTION

• The test tones used in the Auto MCACC Setup are

output at high volume.

THX

®

• THX is a trademark of THX Ltd., which may be

registered in some jurisdictions. All rights reserved.

1

Switch on the receiver and your TV.

Make sure that the TV’s video input is set to this receiver.

2

Connect the microphone to the MCACC SETUP MIC

jack on the front panel.
Make sure there are no obstacles between the speakers
and the microphone.

If you have a tripod, use it to place the microphone so that
it’s about ear level at your normal listening position. If you
do not have a tripod, use some other object to install the

microphone.

1

The Full Auto MCACC display appears once the
microphone is connected.

2

3

Select the parameters you want to set.

3

If the speakers are connected using any setup other than
the Front height setup, be sure to set the

Speaker

System before the Auto MCACC Setup. See Speaker
system setting
on Operating Instructions in CD-ROM.

Note

1 Install the microphone on a stable floor. Placing the microphone on any of the following surfaces may make accurate measurement

impossible:
• Sofas or other soft surfaces.
• High places such as tabletops and sofa tops.

2 If you leave the GUI screen for over five minutes, the screen saver will appear.
3 • When data measurement is taken, the reverb characteristics data (both before- and after-calibration) that this receiver had been storing will

be overwritten. If you want to save the reverb characteristics data before measuring, connect a USB memory device to this receiver and
transfer the data.
• When measurement is taken of the reverb characteristics data other than

SYMMETRY, the data are not measured after the correction. If

you will need to measure after correction data, take the measurement using the EQ Professional menu in the Manual MCACC setup.

MASTER
VOLUME

MCACC SETUP MIC

USB

iPod

iPhone

VIDEO CAMERA

HDMI 5

CONTROL

ON / OFF

Microphone

Tripod

Speaker System

: Normal(SB/FH)

1a.Full Auto MCACC

A/V RECEIVER

Exit

Return

START

EQ Type

: SYMMETRY

MCACC :

M1.MEMORY

1

THX Speaker

:

NO

VSX-LX53_QuickGuide_SVYXJ_ENFRDE.book Page 23 Tuesday, February 23, 2010 8:22 PM

This manual is related to the following products: