Xerox WorkCentre XE90fx-9907 - Manual (Page 60)

8.8
U s e r G u i d e
R E P L A C I N G T H E D R U M C A R T R I D G E
Carefully remove the sheet of black
protective paper from the drum cartridge,
making sure not to leave any torn pieces of
paper in the WorkCentre.
Replace the toner cartridge. Hold the
handle of the toner cartridge so that the
stamped markings on top of the cartridge
are facing upward.
Gently insert the toner cartridge inside
the WorkCentre.
Push where indicated (in the illustration)
until the toner cartridge is fully inside the
WorkCentre and the handle springs back.
Ensure that the WorkCentre power is on.
You must hold in the button indicated and
close the cover at the same time.
Continue to hold the button for three
seconds, then release the button. The
three Copy Contrast LEDs will flash and
return to ready state. If the J2 code is still
present, repeat this step.
10
11
Note: Help the environment by
recycling your used drum cartridge.
Use the recycle sticker packed with the
drum cartridge for instructions on
returning the used drum cartridge to
Xerox.
12
13
14
XE90QRG.BK Page 8 Wednesday, January 5, 2000 9:55 AM