Xerox WorkCentre XE90fx-9907 - Manual (Page 16)

2.8
U s e r G u i d e
P R O G R A M M A B L E F E A T U R E S E T T I N G S
Message display
Indicators light up when there is a fault.
The fault codes will appear in the Message
Display.
Programmable Feature Settings
Settings 0 - 7, 14 and 15
To change the programmable features in
the chart on the following pages, follow
the steps below.
Select the Toner Saver.
Press again and hold the Copy Quality
button for approximately 4 to 6 seconds.
• The light next to Auto will light.
• The lights within the WorkCentre
Diagram will flash.
From the Programmable Features Chart
on page 2.11, select the Program Number
of the feature to be changed. Enter the
selection using the
10 button.
Press Start. The current setting for that
program will flash.
Toner Saver
Photo
Text
Auto
1
2
Copy Quality
Copy Contrast
On-Line/
Off-Line
Clear
Ready
Reduce/Enlargement
Indicators
3
4
XE90QRG.BK Page 8 Wednesday, January 5, 2000 9:55 AM