Xerox WorkCentre XE90fx-9907 - Manual (Page 12)

2.4
U s e r G u i d e
L O A D I N G M E D I A
Gently push the paper release lever back.
The paper will be clamped by the paper
feed roller inside the printer.
If printing onto an envelope:
Ensure that the side to be printed on is
facing upwards (as shown by the imprint
on the paper tray) and the flap on the
reverse side is closed and at the right
when looking from the front of the
printer. Leave a gap of approximately
1/32 in. (1 mm) between the paper guide
and the left edge of the envelope.
Push the paper release lever back. The
paper will be clamped by the paper feed
roller inside the printer.
Do not reuse the misfed paper.
Do not use materials that:
• are composed with glues, inks and
adhesive that could discolor, scorch,
or melt when heat is applied
• have cellophane windows, peel-off
adhesive strips
• are heavily textured, coated or
embossed
• are cotton paper composed of more
than 25% of recycled paper.
5
Note: It is recommended that you load
and print one envelope or
transparency at a time.
6
Note: Paper jams (E1) may
occur if:
• the paper lever is not used.
• the paper tray is overstacked.
• the space between the paper guide
and the left edge of the paper is
greater than 1 mm.
• the paper guide is pushing the
paper so hard that the paper
buckles.
• the paper is not stored properly
and absorbs moisture from the air
(replace the paper).
XE90QRG.BK Page 4 Wednesday, January 5, 2000 9:55 AM