Xerox WorkCentre 7328-7335-7345-7346 con built-in controller-15108 - Manual (Page 30)

Scan to Home (Optional)
Copyright © 200 8 , Xerox Corporation. All rights reserved.
30
Scan to Home (Optional)
The Scan to Home option is supported through the Network Scanning service. Scan to Home
consists of a template file (.xst) stored locally on the device, but in a different directory than
the network scanning templates or mailbox folders.
Users access the Scan to Home template by pressing the
Network Scanning button on the
All Services screen of the User Interface. The device queries LDAP to acquire the
authenticated user’s home directory, or appends the authenticated user’s login name to a
predefined network home path.
See also:
System Administrator Guide : Contains more detail concerning Scan to Home setup.
Interactive User Guide : Contains information on how to Scan to Home.
Prerequisites for Scan to Home
„ The machine must be fully functioning on the network prior to installation.
„ The Scan to Home option must be enabled. For instructions, refer to the Enabling
Options with Software Keys topic in the Options section of the System Administrator’s
Guide. Contact your Xerox Sales Representative if you have not purchased the Scan to
Home option.
„ TCP/IP and HTTP protocols must be configured on the device and fully functional.
This is required to access CentreWare Internet Services to configure Network Scanning.
The Internet Services function is accessed through the embedded HTTP server on the
machine and allows System Administrators to configure scan settings by using an
Internet browser.
„ LDAP authentication must be enabled on the device as explained in the Authentication
section of the System Administrator’s Guide. LDAP is enabled through Internet
Services (the embedded HTTP server on the machine) using the following path: open
your web browser, enter the IP address of the device, select Properties, select Security,
select Authentication Configuration, and finally, select Remotely on the Network for
User Credential validation.
„ The LDAP protocol must be configured for the System (or an Authenticated User) to
log in to the LDAP server. LDAP is configured through Internet Services (the
embedded HTTP server on the machine) using the following path: open your web
browser, enter the IP address of the device, select Properties, select Connectivity, select
Protocols, and finally, select LDAP.