Konica Minolta FK-502 - Manual (Page 182)

Transmission Applications 7
bizhub 750/600 7-45
Tr
ansmission
Ap
plicat
ion
s
Chapter 7
– To release the setting, press [ECM OFF] again.
– The screen is the one that is displayed when 2 lines are used.
5
Press [Yes] when doing [Check Destination].
– By setting [Check Destination] to [Yes], erroneous transmission can
be prevented. For details, see"Check the destination before
sending" on page 7-51.
6
Press [OK].
The Comm. Setting screen will be restored.
7
Press [OK].
The FAX screen will be restored.
8
Set other functions if necessary.
– See "Setting Transmission Conditions" on page 3-10 for
information about setting functions in the FAX screen. See
"Application Functions Overview" on page 7-4 for information
about setting functions in the Fax Application Menu.
9
Designate the destination.
– See "Selecting One Destination" on page 3-19 for designating the
destination.
10
Set the original document.
– See "Placing the Original on the Machine" on page 3-5 for
information about setting the document.
11
Press [Start].
The FK-502 starts transmission.
!
Detail
To cancel transmission, see "Canceling Transmission" on page 3-36.
If the destination is not ready to receive, your call will be redialed. For
information about redialing, see "Recently Dialed" on page 3-28.
If transmission fails, refer to "Cannot Send Messages" on page 5-2.