Konica Minolta Bizhub 215 - Manual (Page 124)

bizhub 215 7-5
7.2 Major messages and troubleshooting 7
[AMS SIZE ERROR] The zoom ratio based on the
combination of the original size
and paper size is outside the
range from 25% to 400% when
the original is copied in the auto
zoom select mode. Load paper of the suitable-size
paper or press Zoom to select a
zoom ratio.
[PAPER SIZE ERROR RESET
PAPER(#XXX)] The paper loaded into the tray
does not match the specified
size. "#" indicates a tray, and
"XXX" indicates the paper size. When you use the paper feeder
unit, remove the loaded paper
and load paper according the
procedure in "Loading paper"
(p. 3-7).
When you are using custom size
paper, refer to "Making copies
on custom size paper" (p. 4-16).
When you use Bypass Tray, re-
move the loaded paper and load
paper according to the proce-
dure in "Loading plain paper in
the Bypass Tray" (p. 4-10).
[MEMORY FULL(PRESS ANY
KEY)] Image data scanned by the
scanner caused a memory over-
flow. Press any key on the Control
Panel. Or turn off the Main Pow-
er Switch, and turn it on again.
(All scanned data is erased.)
Image data received from the
computer has caused a memory
overflow. Press any key on the Control
Panel. Or turn off the Main Pow-
er Switch, and turn it on again.
(All scanned data is erased.)
[MAINTENANCE CALL(M1)
CALL SERVICE] Maintenance is due. Contact your service representa-
tive.
[MAINTENANCE CALL(M2)
CALL SERVICE] The time for replacement of
Drum Unit. Contact your service representa-
tive.
[MACHINE TROUBLE SERVICE
CALL (CXXXX)] An error has occurred in this ma-
chine. Turn off the Main Power Switch
of this machine, then turn it on
again. If this error recurs, contact
your service representative.
Message Cause Correction action