Konica Minolta Bizhub 215 - Manual (Page 121)

bizhub 215 7-2
7.1 If this copy is output 7
7 If you suspect a failure then do the following
7.1 If this copy is output
Copy status Major cause Correction action
Copy density/color is light. Is the copy density set to
"Light"? Press Density to set the desired
copy density. (p. 4-4)
Is the paper damp? Replace with new paper. (p. 3-7)
Copy density/color is dark. Is the copy density set to
"Dark"? Press Density to set the desired
copy density. (p. 4-4)
Was the original pressed firmly
enough against the Original
Glass? Position the original so that it is
pressed closely against the Orig-
inal Glass. (p. 3-12)
The ink runs or a copied image
is blurred. Is the paper damp? Replace with new paper. (p. 3-7)
Was the original pressed firmly
enough against the Original
Glass? Position the original so that it is
pressed closely against the Orig-
inal Glass. (p. 3-12)
There are streaks on the copy.
There are dark specks or spots
throughout the copy.
Is the Original Glass dirty? Wipe the Original Glass using a
soft, dry cloth. (p. 8-5)
Is the Original Pad dirty? Clean the Original Pad using a
soft cloth dampened with a mild
detergent. (p. 8-6)
Was the original printed on high-
ly translucent material, such as
diazo photosensitive paper or
OHP transparencies? Place a blank sheet of paper on
top of the original. (p. 3-13)
Is a 2-sided original being cop-
ied? If a thin 2-sided original is being
copied, the print on the back side
may be reproduced on the front
side of the copy. Press Density to
select a lighter background den-
sity. (p. 4-4)
The end of the service life of
Drum Unit. Contact your service representa-
tive.