Konica Minolta BIZHUB 223 - Manual (Page 68)

bizhub 423/363/283/223 2-53
2.12 Protecting Data in the HDD 2
11
A confirmation message appears. Select [Yes] and touch [OK].
12
Make sure that a message appears prompting you to turn OFF and then ON the main power switch.
Now, turn OFF and then turn ON the main power switch.
% When the main power switch is turned off, then on again, wait at least 10 seconds to turn it on after
turning it off. if there is no wait period between turning the main power switch off, then on again, the
machine may not function properly.
Here is the sequence, through which the main power switch and sub power switch are turned on
and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn on the main power switch
→ Turn on the sub power switch
% To set the [Overwrite HDD Data], go to step 13.
13
Call the HDD Settings screen on the display from the control panel.
% For the procedure to call the HDD Settings screen on the display, see steps 1 and 2 of page 2-50.
14
Touch [Overwrite HDD Data].