Konica Minolta BIZHUB 223 - Manual (Page 183)

bizhub 423/363/283/223 4-36
4.5 HDD Backup Utility 4
6
Type the 8-digit Administrator Password registered in the machine in the "Administrator Password"
box.
% If the "Save the administrator password" check box is selected, the Administrator Password en-
tered is stored in the PC being used. If you do not want the Administrator Password stored, clear
the "Save the administrator password" check box.
7
Click [Next].
% If a wrong Administrator Password is entered, a message that tells that the Administrator Password
does not match appears. Enter the correct Administrator Password.
% If the Enhanced Security mode is set to [ON], entry of a wrong password is counted as unauthorized
access. If a wrong Administrator Password is entered a predetermined number of times (once to
three times) or more set by the Administrator of the machine, a message appears that tells that the
machine accepts no more Administrator Passwords because of unauthorized access for any sub-
sequent entry of the Administrator Password. The machine is then set into an access lock state. To
cancel the access lock state, settings must be made by the Service Engineer; or, turn off, and then
turn on, the main power switch of the machine. If the main power switch is turned off and on, the
access lock state is canceled after the lapse of time set for [Release Time Settings]. When the main
power switch is turned off, then on again, wait at least 10 seconds to turn it on after turning it off. If
there is no wait period between turning the main power switch off, then on again, the machine may
not function properly.
Here is the sequence, through which the main power switch and sub power switch are turned on
and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn on the main power switch
→ Turn on the sub power switch
8
Check the data that has been set and click [Start].