Konica Minolta bizhub 200 - Manual (Page 31)

2 Saving documents
2-8 200/250/350
Sav
ing d
o
c
u
me
nts
Ch
apte
r 2
Saving data by touching a one-touch dial button
Program a one-touch dial button with the location of a box where data is to
be saved. For details on programming one-touch dial buttons, refer to “Con-
trol Panel Settings” on page 5-2.
2
Note
In addition to touching a one-touch dial button to select it, it can be se-
lected by entering the number of the one-touch dial button or by search-
ing for it by name. For details on these procedures, refer to the User’s
Guide [Network Scanner Operations].
To save scan data using a one-touch button
1
Load the document.
Function Description Page
Reference
Setting 1 TX Report Select the conditions for printing the results report. p. 2-15
2in1 Select whether or not to send the data using the “2in1”
function (reducing two pages to fit in a single page). p. 2-17
2-Sided TX Select whether or not a double-sided transmission is
performed. The position of the binding margin and the
page orientation can also be specified. p. 2-18
Setting 2 Priority TX Select whether or not the data is sent (saved) with pri-
ority over the other jobs. p. 2-20
Timer TX
Setting Specify the time for sending (saving) the data. Touch
[Enter] to specify that the data will be sent (saved) at
the specified time. p. 2-20
Stamp Specify whether the scanned image is stamped to in-
dicate that it has been scanned. In addition, the doc-
ument must be loaded into the ADF.
2
Note
In order to use the “Stamp” function, op-
tional stamp unit must be installed.
p. 2-21
Network File Name Type in the name of the file to be saved. Up to 16 char-
acters can be entered. p. 2-22
Email Noti-
fication Select a recipient registered with a one-touch dial but-
ton where an e-mail message is to be sent to inform
the recipient that the file has been saved. p. 2-23