Kramer Electronics VP-8x8TP - Manual (Page 40)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Default EDID
36
Switching Protocol
P2000 -> P3000 P3000 -> P2000
Command: 0x38, 0x80, 0x83, 0x81 Command: #P2000
Front Panel: Press and hold Output 1 and Output 3
simultaneously
Front Panel: Press and hold Output 1 and
Output 2 simultaneously
Ethernet Factory Default Values
To reset the IP settings to the factory reset values, power cycle the device while holding in the Factory Reset
button, located on the rear panel of the unit
IP Address: 192.168.1.39
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.1
TCP Port #: 5000
UDP Port #: 50000
Maximum UDP Ports: 10
Maximum TCP Ports: 4
14 Default EDID
The default EDID is stored in all inputs.
Monitor
Model name VP-8X8TP
Manufacturer KRM
Plug and Play, ID KRM0808
Serial number 2
Manufacture date 2009, ISO week 10
EDID revision 1.3
Input signal type Analog 0.700, 0.000 (0.7 Vp-p)
Sync input support Separate, Composite, Sync-on-green
Display type RGB color
Screen size 360 x 290 mm (18.2 in)
Power management Standby, Suspend, Active off/Sleep
Extension blocs None
DDC/CI Not supported
Color characteristics
Default color space sRGB
Display gamma 2.0
Red chromaticity Rx 0.611 - Ry 0.329
Green chromaticity Gx 0.312 - Gy 0.559
Blue chromaticity Bx 0.148 - By 0.131
White point (default) Wx 0.320 - Wy 0.336
Additional descriptors None
Timing characteristics
Range limits Not available
GTF standard Not supported
Additional descriptors None
Preferred timing Yes
Native/preferred timing 1024x768p at 60Hz (4:3)
Modeline "1024x768" 65.000 1024 1048 1184 1344 768 771 777 806 -hsync –
vsync