Safety instructions – BrandTech Scientific PLT unit Pipette Leak Testing Unit User Manual
Page 36
Please read the following carefully!
This instrument may sometimes be used with hazardous materials, operations, and equipment. It is beyond
the scope of this manual to address all of the potential safety risks associated with its use in such applica-
tions. It is the responsibility of the user of this instrument to consult and establish appropriate safety and
health practices and determine the applicability of regulatory limitations prior to use.
Safety Instructions
!
1. Every user must read and understand this
operating manual before operation.
2. Follow general instructions for hazard preven-
tion and safety instructions; e.g., wear protec-
tive clothing, eye protection and gloves.
When working with infectious or other hazard-
ous samples, all appropriate regulations and
precautions must be followed.
3. Never use the instrument in an atmosphere
with a danger of explosion.
4. The instrument should only be used for the
leak testing of pipettes that operate on the
air displacement principle. Observe operating
exclusions (s. page 37)! If in doubt, contact
the manufacturer or supplier.
5. Always use the instrument in such a way that
neither the user nor any other person is endan-
gered.
6. When testing air displacement pipettes with
mounted tips, employ only unused tips.
7. Never use force on the instrument!
8. Use only original manufacturer's accessories
and spare parts. Do not attempt to make any
technical alterations.
9. Only authorized service personnel may repair or
service the instrument.
10. Always check the instrument for visible dam-
age before use. If there is a sign of a potential
malfunction, immediately stop the test. Consult
the 'Troubleshooting' section of this manual
(see page 63), and contact the manufacturer if
needed.
11. The AC adapter has to be protected against
moisture and must be used only for this instru-
ment.
36
Warning!
Improper use of the instrument (short-circuit, mechanical damage, over-
heating etc.) may cause the explosion.