NOVUS AirGate-Modbus User Manual
Airgate-modbus, Instructions manual, V1.1x c
Table of contents
Document Outline
- INTRODUction
- SPECIFICATIONS
- CONNECTION AND INSTALLATION
- operation
- OPERATION MODES
- USING THE OPERATION MODES
- LONG REACH APPLICATION
- SETUP SOFTWARE
- CONFIGURATION MODES
- DETERMINATION AND SELECTION OF THE SERIAL PORT (COM) - WINDOWS
- CONFIGURATIONS - AIRGATE-MODBUS
- BASICS
- PAN ID
- modbus ADDRESS
- Each AirGate-Modbus must have a unique Modbus address. This address should be set before connecting the device to the network. Modbus communication frames addressed to AirGate-Modbus will be handled by itself. Frames with any other address will be for...
- This address is set in factory as 248, an invalid Modbus address, to avoid initial conflict with any other already configured Modbus device in the network and should be changed to a unique address as soon as possible. While in Configuration Mode (stat...
- Baud rate
- PARITY
- Timeout
- OPERATION MODES
- ADVANCED
- FIRMWARE UPDATE
- BASICS
- DATA COMMUNICATION - SERIAL
- data communication – Wireless
- MODBUS commands
- DESCRIPTION OF SOME REGISTERS
- HOLDING REGISTERS TABLE
- SUPPORTED MODBUS REGISTERS
- ACCESSORIES
- WARRANTY