NOVUS AirGate-Modbus - Manual (Page 10)

AirGate-Modbus
NOVUS AUTOMATION 10/22
CONFIGURATION MODES
AirGate-Modbus is configurable through DigiConfig software via USB interface, being necessary to put the device in
“setup mode”. To enter this mode, simply press the SETUP BUTTON, checking that the STATUS LED now flashes
slowly (approximately once per second). In “setup mode” the device stops behaving as a gateway from a Modbus
network and starts to accept the configurations. In the main screen of the DigiConfig software (Fig. 12) the following
configuration must be seen:
• Initial Address = 246
Fig. 10 - DigiConfig main screen
To edit the configurations of the AirGate-Modbus, after clicking the Search button, you must select it in the tree to the
left of the main screen.
To quit “setup mode“, you must press the SETUP BUTTON again, “Cancel”, or “Apply” a configuration. In this moment,
the device is reset and starts to operate according to the last applied configuration.