Pulsafeeder PulsaPro 900 EN - Manual (Page 13)

9
5. Installation
5.1 Location
When selecting an installation site or designing a skid package, consideration should be given to
access for routine maintenance.
PulsaPro 900
pumps are designed to operate indoors and outdoors. At a minimum, a
covering to protect the pump from direct weather and sunlight is required. External heating
and/or the use of synthetic lubricants for the gearbox is recommended if ambient temperatures
below 20
°C (0°F) or above 40°C (104°F) are anticipated. Check with the factory if you are
concerned with the suitability of the operating environment.
5.2 Mounting
The pump must be rigidly bolted to a solid and flat foundation to minimize vibration, which can
loosen connections. Bolt each base with a minimum of 1” diameter studs with flat and lock
washers in 4 locations per base (note: the quad configurations include 2 bases). The pump must
be level within 2
°. This will assure that the oil is maintained at the proper level and that the
check valves can operate properly.
Figure 7
mm
[inch]